Details

screw size:

35 mm

injection shot weight in Polysterol:

132 g/PS

closing pressure:

1000 kN

daylight:

370 x 370 mm

opening stroke:

500 mm

mould height - Max./min.:

350 mm

control:

Selogica 

daylight between platens - max.:

850 mm

Description

ONLY 28,000 OPERATION HOURS

- C Series III
- wear resistant plastification unit
- Selogica control
- Technology step 2 - servo-controlled / two-circuit
pump tecvhnology
- iicrease in the minimum mold installation height
350 mm, the opening stroke remains unchanged
- connection / electrical preparation for retrofitting
the moild blow unit 1
- lateral protection increased to safety level, open at the top
- epuipment for injection into the mold parting line at
horizontal clamping unit, with extended hydraulic hoses
as well as an electrically and mechanically secured protective hood
- electrical conveyor belt (short version)
- 8 freely programmable inputs/outputs
- Printer interface
- Interface for PC keyboard
- additional signal element for
acoustic fault indication
- Cooling water distribution with 4 free circuits,
manually adjustable
- 1 Programmable machine-related cooling circuit
regulated
- Arburg equipment packages No.: 1-2-3,5,6,7
- Servo-controlled injection regulation,this means that the following
parameters are regulated:
- Injection current or injection speed
- holding pressure
- movements and force build-up of the nozzle
- Ramp course for movements to the target point for the nozzle
- Tool monitoring by ejector plate protection (interface)
- Control extension for additional signals
- special mold clamping plate (see photos)
- Machine equipped with robot Multilift H incl. housing

This machine is cleaned and functionally tested in our house. The machine can be tested in our house in running condition.